Sliding Table - Grizzly G0451 Instruction Manual

Sliding Table

Components and Hardware Needed:
T-Nut M12-1.75 ....................................................1
Flat Washer 12mm .............................................1
Push Handle M12-1.75 x 12 ................................1
Edge Shoe ..........................................................1
Hold Down ..........................................................1
Sliding Table End Handle ...................................1
Sliding Table Lock Plate .....................................1
Tools Needed:
Hex Wrench 4mm ...............................................1
To assemble the sliding table components:
1. Remove the red shipping brace (Figure 39)
and the screws indicated. Set the screws
aside for use in the following steps.
Figure 39. Sliding table.
-28-
QTY
QTY
Red Shipping
Brace
2. Install the lock plate as shown in Figure 40
using 4 of the screws removed in the previ-
ous step.
Figure 40. Installing the lock plate.
3. Install the end handle, as shown in Figure
41, using the remaining screws removed in
Step 1.
Figure 41. Sliding table end handle.
4. The sliding table is locked in place when the
table lock is in the position shown in Figure
41. Rotate the table lock 180˚ to unlock the
sliding table.
G0451 14" Sliding Table Saw
Lock Plate
Table Lock
End Handle