Rip Fence - Grizzly G0451 Instruction Manual

Rip Fence

Components and Hardware Needed:
Rip Fence .......................................................... 1
Rip Fence Round Rail ....................................... 1
Rip Fence Body ................................................. 1
Stud M12-1.75 x 115 .......................................... 4
Hex Nut M12-1.75 ............................................ 12
Flat Washer 12mm ............................................ 8
Lock Washer 12mm ........................................... 4
Lock Washer 8mm ............................................ 1
Cap Screw M8-1.25 x 16 ................................... 1
End Washer 8mm .............................................. 1
Adjustable Ring & Set Screw ............................ 1
Lock Handle M10-1.5 x 12 ................................. 2
Knob M10-1.5 x 70 ............................................ 1
Tools Needed:
Hex Wrench 3mm ...............................................1
Socket or Wrench 18mm ....................................1
To install the rip fence:
1.
Thread four M12-1.75 x 115 studs into the
round rail.
2.
Thread an M12-1.75 hex nut onto each stud
and tighten the nuts against the round rail.
3. Thread an M12-1.75 hex nut and a flat wash-
er half way onto each stud.
4.
Insert the studs into the table as shown in
Figure 26. Loosely secure with an M12-1.75
hex nut, lock washer, and a flat washer on
each stud.
Figure 26. Installing the round rail.
-24-
5.
Slide the rip fence body onto the rail, then
place the adjustable ring on the sliding table
end of the rail and secure the ring with the
set screw as shown in Figure 27.
Qty
Qty
Figure 27. Securing the adjustable ring.
6. Thread the lock handles (Figure 28) into the
rip fence body and loosely install the fine
adjustment knob.
Figure 28. Rip fence handles.
7.
Place the end washer on the end of the rip
fence rail and secure it with the M8-1.25 cap
screw and lock washer.
Lock
Handles
Fine Adjustment
Knob
G0451 14" Sliding Table Saw