Remove Jammed Media - Oce TCS500 User Manual

Remove jammed media

Remove jammed media
Introduction
If a media jam occurs, the system produces a double audio signal. The red LEDs of
the printer operator panel remain illuminated. If a jammed media error occurs on the
system, immediately remove the jammed media to prevent damage to the printer.
The system handles the error recovery for the jammed media through a series of
dialogue boxes. Use the following procedure to remove the jammed media.
How to remove jammed media
Attention: Never use a knife to cut loose the jammed media. When you use a
knife to cut loose the media, you can damage the printer.
Open the cover or door that the printer operator panel indicates.
1.
[213]
Use a pair of scissors to cut loose the media.
2.
Remove the jammed media from the output side of the printer.
3.
[214]
Press the softkey for 'Done' to confirm that you removed the jammed media.
4.
Close the cover or door that the printer operator panel indicates.
5.
268 Chapter 12 System messages and solutions