Do an extended copy job
Do an extended copy job
Introduction
The main steps of an extended copy job are the following.
Feed the original.
Define the job settings.
Press the green start key.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer queue of
the Océ Queue Manager, a scan-to-file job appears in the selected destination of the
Océ Scan Manager.
How to copy on the Océ TCS500
Place the original face down and right aligned.
1.
The scanner takes the original.
[130]
[130] Place the original face down and right aligned
Define the job settings.
2.
164
Chapter 7 Use the Océ TCS500 for copy jobs