Make A Copy And Remove A Strip - Oce TCS500 User Manual

Make a copy and remove a strip

Make a copy and remove a strip
Introduction
You can use a strip to file a drawing. Use 'Add strip' to copy an original without a
strip and add a strip to the copy. Use 'Remove strip' to copy an original with a strip
and remove the strip from the copy. You can adjust a strip at the leading or trailing
side of a copy.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer queue of
the Océ Queue Manager, a scan-to-file job appears in the selected destination of the
Océ Scan Manager.
Attention: When you remove a strip, make sure that you copied all the required
information.
180 Chapter 7 Use the Océ TCS500 for copy jobs