Oce TCS500 User Manual page 246

Replace the media
Press the key for 'Finish' to confirm the settings and to exit the wizard.
4.
How to correct the media type defined on the system
Attention: You need only to correct the type of media when an incorrect media
type was defined when the roll was loaded.
If you define a type of media that is different from the media type loaded on the
system, the print quality decreases and pollution of the system can occur.
Press the On-line / off-line key to set the printer off-line.
1.
Use the upper softkeys to scroll to the 'Change media type' card.
2.
[190]
[190] Change media type card on the off-line screen
Press the softkey below the 'Change media type' card to enter the wizard.
3.
An introduction screen displays the message 'Use the retract button to replace a roll.
4.
Press Next to change the media type for a loaded roll.'
[191]
[191] Introduction screen
If you do not want to load a new roll, use the upper right softkey to continue the
wizard at the introduction screen. If you do want to load a new roll, press the retract
button to change the media roll.
If you press the retract button, the screen displays the message 'Load new media'.
5.
Change the media roll as described in the above sections.
If you do not press the retract button and continue in the 'Change media type' wizard,
6.
the screen displays the message 'Select roll to change media type for...'. Use the
lower softkeys to select the correct roll to change the media type for.
246 Chapter 11 Maintain the Océ TCS500
(see figure 182 on page 242)