Oce TCS500 User Manual page 245

How to select the settings for the new roll of media
Attention: After you load a new roll of media, the screen of the printer operator
panel displays a wizard. Use the wizard to define the media type and the cut
option for the new media roll.
The screen displays the message 'Select media type on roll (number)'. Use the lower
1.
softkeys to select the media type.
[188]
[188] Select the media type
Note: The media types you can see on the screen are the three most recently used
media types. The default media type is the media type that you defined for the media
roll the last time. If you must select another media type, you can scroll down with the
lower softkey and select 'More...'. Then a list displays of all the media types that you
can select.
Press the key for 'Next' to enter the cut option screen. The system displays the
2.
question 'Cut?'
Use the lower softkeys to select the cut option for the media.
3.
[189]
[189] Select the cut option
Select one of the following.
'Yes, long strip'
Cut the media with a full roll rotation feed (50 cm) before the printer cuts the
media. You can use this option when the media is damaged or polluted with, for
example, tape residue.
'Yes, short strip'
Cut the media with the shortest possible strip (20 cm).
'No'
No media cut.
Replace the media
245