System Board - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

System Board

Description
System board for use in models without Windows 8
System board for use in models with Windows 8 Standard
System board for use in models with Windows 8 Professional
System board with DisplayPort 1.2 support for use in models without Windows 8
System board with DisplayPort 1.2 support for use in models with Windows 8 Standard
System board with DisplayPort 1.2 support for use in models with Windows 8 Professional
Front I/O panel
CAUTION:
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the memory modules
4. Remove the front fan
5. Remove the optical drive
6. Remove the hard drive
7. Remove the optical drive rail
8. Remove the heat sink
9. Disconnect the rear fan cable from the system board.
10. Disconnect any remaining cables connected to the system board, noting their location for
reinstallation.
11. Remove the front I/O panel:
a. Remove the Torx T15 screw from the right side of the panel that secures it to the front of
the chassis.
Figure 9-34
Be very careful when removing or replacing the system board to prevent damaging it.
(Front Fan on page
(Removing the Optical Drive on page
(Hard Drive on page
(Optical Drive Rail on page
(Heat sink on page
I/O panel screw
(Preparation for Disassembly on page
(Access Panel on page
(Memory on page 214).
218).
222).
231).
Spare part number
657095-001
657095-501
657095-601
711787-001
711787-501
711787-601
587458-001
207).
208).
219).
227).
System Board 241