Table of Contents
Advertisement
Heat sink
Description
Heat sink
The heat sink is secured by four Torx screws. It does not have an attached fan.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Lift the front fan up and place it on top of the optical drive to access the front bezel release tabs.
You do not need to disconnect the fan cable from the system board.
4.
Loosen the four Torx T15 screws that secure the heat sink to the system board, and then lift the
heat sink from the system board.
Figure 9-25
CAUTION:
an X) to even the downward forces on the processor to avoid damage that could require
replacing the system board.
Loosening the heat sink screws
Heat sink retaining screws should be removed in diagonally opposite pairs (as in
(Preparation for Disassembly on page
(Access Panel on page
Spare part number
587456-001
207).
208).
Heat sink 231
Hide quick links:
Advertisement
Table of Contents
