Speaker - HP Elite 8300 Series Convertible Minitower Maintenance And Service Manual

Speaker

Description
Speaker
The speaker is secured to the front of the chassis between the fan and the I/O ports. Remove the
screws from the outside and then remove the speaker from the inside.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Disconnect the speaker cable from the white system board connector labeled SPKR.
5. On the outside of the chassis, remove the two Torx T8 screws that secure the speaker to the
chassis (1), and then from the inside of the chassis, slide the speaker up to remove it (2).
Figure 9-24
To install the speaker, reverse the removal procedure.
230 Chapter 9 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
(Front Bezel on page
Removing the speaker
(Preparation for Disassembly on page
(Access Panel on page
209).
Spare part number
689384-001
207).
208).