Ch100 Control - Blodgett COS-6 Installation And Operation Manual

1
4
5
7
8
9
10
11
14
16
19
20
21
24
Figure 16
CONTROLS IDENTIFICATION
1. LOW WATER FILL LIGHT --- indicates the wa-
ter level in the steam generator is too low. The
heating element shuts off automatically in or-
der to avoid damage. Turn on the water tap or
2
check to see if the flow of water is stopped.
2. DON'T STEAM LIGHT --- indicates the unit is
3
too hot to operate in the steam mode. Place
the unit in the Cool Down mode until the tem-
perature is below 210_C (130_F). This light
does not inhibit steam production.
3. POWER ON LIGHT --- indicates the unit is in
Steam, Hot Air or Combi.
6
4. MODE SELECTOR SWITCH --- turns power
to the oven on or off. Allows selection of
Steam, Hot Air, Combi or Cool Down Modes.
5. TIME DISPLAY --- displays time and other in-
formation related to oven function.
6. TEMPERATURE DISPLAY --- displays tem-
perature and other information related to oven
function.
12
7. MIN/SEC LIGHT --- when lit indicates min-
utes/seconds timing mode.
13
8. HOUR/MIN LIGHT --- when lit indicates hour/
minute timing mode.
15
9. _F LIGHT --- when lit indicates control is oper-
ating in Fahrenheit mode.
17
10. _C LIGHT --- when lit indicates control is oper-
18
ating in Celsius mode.
11. HEAT LIGHT --- when lit indicates the control
22
is calling for heat.
23
12. TIME ARROW KEYS --- press to increase or
decrease the time.
13. TEMP ARROW KEYS --- press to increase or
decrease the temperature.
14. HOLD LIGHT --- when lit indicates a hold time
has been programmed for the corresponding
product key.
15. FAN LIGHT --- when lit indicates the fan is set
to ON. When flashing, indicates the fan is set
to pulse for the corresponding product key.
16. HOLD KEY --- press to program a hold time for
the corresponding product key.
17. FAN KEY --- press to program the fan option
for the corresponding product key.
21
Operation

CH100 Control