Blodgett COS-6 Installation And Operation Manual page 10

To Stack two COS-8Es
1. Install 6" legs or casters on the bottom unit,
using three .50-13 UNC bolts provided per leg
or caster. If casters are used, ensure that the
casters with brakes are located on the front of
the oven. See STEP 1.
2. Lift and mount the upper unit onto the lower
unit. Flush the edges on all four sides. Remove
the louvered panel and body back of both
units. Remove the lower body back from the
top unit. See STEP 2.
3. Bolt the upper and lower units together with
the .50-13 UNC bolts provided. See STEP 3.
4. Attach copper Tee, gray hose and clamps to
the drain outlet of both units.
Do Not Remove Body Top
STEP 1
Bolt Through
Holes Closest to
Oven Center
STEP 3 (Rear of Units)
Caster
with Brakes
STEP 3
Figure 7
NOTE: The installation plumber is responsi-
ble for connections between units and
connection to drain. Use a 24" section
on top unit Tee to raise breather vent.
See STEP 4.
WARNING!!
Improper installation, adjustment, alter-
ation service or maintenance can cause
property damage, injury or death. Read
the installation, operation and mainte-
nance instruction thoroughly before
installing or servicing this equipment.
Remove
Body Back
Remove
Lower
Body Back
Remove
Body Back
STEP 2
Breather Vent
Plumber Installed
Connection
24.00" Long
Tee, Hose
and Clamps
Plumber Installed
Connection
Tee, Hose
and Clamps
Plumber Installed
Connection To Drain
STEP 4
9
Installation
Stacking
Remove
Louvered
Panel
and Save
Screws