Blodgett COS-6 Installation And Operation Manual page 21

Operation
IM2000 Control
Programming an action alarm:
An action alarm is an alarm that sounds during the
cook cycle. An action alarm can be used to alert
the operator that the product needs to be turned
or stirred, etc. There are three action alarms avail-
able. They are timed from the end of the cook
cycle.
1. The top display reads PrE1. The bottom dis-
play gives the current first action alarm.
2. To change, press the TOGGLE/CLEAR KEY
(16). Use the product keys to enter a new ac-
tion alarm time.
NOTE: This action alarm must be less than the
total cook time for the product.
3. Press the SCAN KEY (17) to accept the first
alarm time. The top display reads PrE2. The
bottom display gives the current second ac-
tion alarm.
4. To change, press the TOGGLE/CLEAR KEY
(16). Use the product keys to enter a new ac-
tion alarm time.
NOTE: This action alarm must be less than the
first action alarm.
5. Press the SCAN KEY (17) to accept the first
alarm time. The top display reads PrE3. The
bottom display gives the current third action
alarm.
6. To change, press the TOGGLE/CLEAR KEY
(16). Use the product keys to enter a new ac-
tion alarm time.
NOTE: This action alarm must be less than the
second action alarm.
7. Press the SCAN KEY (17). The programming
for this recipe is now complete.
Additional product keys may be programmed at
this time.
Exiting the program mode:
1. When all desired product keys have been pro-
grammed press the PROGRAM KEY (15). The
control returns to standby.
OPERATION
Oven/Steamer Startup:
1. Press the POWER ON/OFF KEY (11). The TOP
DISPLAY (1) reads FLUH. The BOTTOM DIS-
PLAY (2) begins a 1:30 countdown as the
steam generator flushes.
2. The top display reads FiLL. The bottom dis-
play counts up as the steam generator fills.
The maximum fill time is 10:00.
3. The top display reads StbY and the bottom dis-
play gives the current temperature.
To begin a cook cycle from standby:
1. Press the desired PRODUCT KEY (20) fol-
lowed by the ENTER KEY (18). The control
brings the oven to the programmed tempera-
ture. The bottom display reads either Hi or Lo
as the units comes to temperature.
2. As the unit reaches the programmed tempera-
ture the bottom display reads rEdY. An audible
alarm sounds and shuts off automatically.
3. Load the product into the unit. Press the prod-
uct key selected in step 1. The top display
gives the cook temperature. The bottom dis-
play counts down the cook time.
When the selected product uses either steam
or combi modes, the bottom display reads b ---
Lo if the steam generator has not reached
180_F. The cook operation will be held and the
LOCK OUT LIGHT (10) illuminates until the
steam generator reaches 180_F. Then the bot-
tom display returns to rEdY. Press the product
key again to continue the cook process.
NOTE: Press and hold the product key at any
time to cancel a cook cycle.
Using action alarms:
1. If the recipe includes a action alarm, the dis-
play flashes and an audible alarm sounds.
The alarm cancels itself after five seconds.
During the alarm the display flashes the alarm
time and continues to count down.
Ending a cook cycle:
1. When the cook time expires an alarm sounds
to alert the operator to remove the product.
Press the product key to silence the alarm.
The top display reads StbY. The bottom dis-
play give the actual temperature.
20