Decalcification - Blodgett COS-6 Installation And Operation Manual

WARNING!!
Protective clothing and eyewear should
be worn while using cleaning agents.
1. Turn the Mode Selection Switch (1) to the
STEAM mode. Wait until steam is produced.
This will ensure that the water in the steam
generator is hot.
2. Turn the Mode Selection Switch (1) to the
COOL DOWN mode and leave the door open.
Let the oven compartment cool to 66_C
(150_F). This ensures that the Drain/Flush
switch will function in STEP 8.
3. Turn the Mode Selection Switch (1) to OFF.
4. In a suitable size container, mix together the
deliming solution and hot tap water. Refer to
the following chart for the proper mixture:
Deliming
Model Solution
COS-6 354 ml
COS-101 532 ml
COS-101S 532 ml
COS-8E 887 ml
COS20E 798 ml
NOTE: These volumes are approximate. You
may need slightly more or less hot wa-
ter depending on your site.
5. Remove the Deliming Port Cap. Attach the
supplied Funnel and Hose Assembly (3) to the
deliming inlet.
6. Open the Deliming Port Valve (2) and pour in
the deliming mixture. Stop pouring when the
funnel stops draining. This is the correct
amount for your site.
7. Shut the Deliming Port Valve (2). Screw on the
Deliming Port Cap. Let the mixture stand for 20
minutes. In areas of the country with hard wa-
ter, allow the mixture to stand for 1 hour.
8. Depress and hold the Drain/Flush Switch (4)
in the FLUSH position for 90 seconds. This
completes the deliming procedure.
Hot Tap
Water
2.8 liters
4.7 liters
4.7 liters
9.5 liters
8.5 liters
25
Maintenance

Decalcification

3
open
2
close
1
Figure 18
4