Blodgett COS-6 Installation And Operation Manual page 20

PROGRAMMING THE PRODUCT KEYS
Entering the program mode:
1. Press the PROGRAM KEY (15). The top dis-
play reads CodE.
2. Use the PRODUCT KEYS (20) to enter the pro-
gramming access code: 4 2 1 3. Press the EN-
TER KEY (18). The top display reads Prod.
3. Press the desired product key followed by the
ENTER KEY (18).
Programming the cook time:
1. The top display reads P1. The bottom display
gives the current programmed cook time.
2. To change, press the TOGGLE/CLEAR KEY
(16). Use the product keys to enter a new cook
time in the bottom display.
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to cook temperature.
Programming the cook temperature:
1. The top display reads P1. The bottom display
gives the current programmed cook tempera-
ture.
2. To change, press the TOGGLE/CLEAR KEY
(16). Use the product keys to enter a new cook
temperature in the bottom display.
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to length of steam cycle.
Programming length of steam cycle:
1. The top display reads SPr1. The bottom dis-
play gives the current programmed length of
the steam cycle in percent of one minute.
2. To change, press the TOGGLE/CLEAR KEY
(16). Use the product keys to enter a new
steam time in the bottom display.
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to damper open/closed.
Programming damper status:
1. The top display reads DAP1. The bottom dis-
play gives the current damper status. Normal-
ly the damper is closed when in combi or
steam mode and open in convection and cool
down modes.
2. Press the TOGGLE/CLEAR KEY (16) to toggle
the damper between open and closed.
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to cook mode.
Programming the cook mode:
1. The top display reads CA1. The bottom dis-
play gives the current programmed cook
mode.
2. To change, press the TOGGLE/CLEAR KEY
(16) to scroll through the cook mode options.
The cook modes are:
a.) C1 = hot air (convection)
b.) C2 = steam
c.) C3 = combi
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to fan speed.
Programming the fan speed:
1. The top display reads FAn1. The bottom dis-
play gives the current programmed fan
speed.
2. To change, press the TOGGLE/CLEAR KEY
(16) to scroll between hi and lo fan.
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to timing mode.
Programming the timing mode:
There are two options for the timing mode:
Straight and Flex. Flex time extends the cooking
time when the temperature is lower than the set-
point.
1. The top display reads P1. The bottom display
gives the current programmed timing mode.
2. To change, press the TOGGLE/CLEAR KEY
(16) to scroll between straight and flex.
3. Press the SCAN KEY (17) to advance the pro-
gramming mode to action alarm mode.
19
Operation
IM2000 Control