Muratec F-110 Field Engineering Manual page 38

Signal
RXD0/GIP[0]
RXD1/GIP[1]
RXD2/GIP[2]
nEINT0/GIP[3]
nEINT1/GIP[4]
nEINT2/GIP[5]
nXDREQ/GIP[6]
TXD0/GOPA[0]
TXD1/GOPA[1]
TXD2/GOPA[2]
nXDACK/GOPA[5]
TONEOUT/GOPA[3]
nWDTO/GOPA[4]
nIOWR/GOPA[10]
nIORD/GOPA[9]
CLKOUT/GOPA[6]
nECS2/GOPA[8]
TCK
TMS
TDI
nTRST
TDO
GIOP[10:0]
TEST0
TEST1
TEST2
Pin No. I/O Type
194 I1
192 I1
190 I1
8 I3
9 I3
10 I3
199 I3
193 O1
191 O1
189 O1
200 O1
188 O1
187 P3
161 O1
162 O1
180 O1
14 O1
132 I2
135 I2
133 I2
136 I2
134 O1
137~140,
I/O4
173~179
169 I2
170 I2
171 I2
Receive data input for the UART0. RXD0 is the UART0
channel's input signal for receiving serial data.
Receive data input for the UART1. RXD1 is the UART1
channel's input signal for receiving serial data.
Receive data input for the UART2. RXD2 is the UART2
channel's input signal for receiving serial data.
External interrupt request input nEINT0.
External interrupt request input nEINT1.
External interrupt request input nEINT2.
External DMA request.
Transmit data output for the UART0. TXD0 is the UART0
channel's output for transmitting serial data.
Transmit data output for the UART1. TXD1 is the UART1
channel's output for transmitting serial data.
Transmit data output for the UART2. TXD2 is the UART2
channel's output for transmitting serial data.
External DMA acknowledge. This active low output signal is
generated whenever a DMA transfer is completed.
Tone generator output.
Reset out by watch dog timer.
External output write strobe
External output read strobe
Clock for external chip
External memory chip select 2.
JTAG TCK interface in MDS mode.
JTAG TMS interface in MDS mode.
JTAG TDI interface in MDS mode.
JTAG nTRST interface in MDS mode.
JTAG TDO interface in MDS mode.
General I/O port.
Test 0 pin. At normal operation this pin must be connected
to GND.
Test 1 pin. At normal operation this pin must be connected
to GND.
Test 2 pin. At normal operation this pin must be connected
to GND.
Circuit Description
Description
4-5