Program Setup; Output - Axis 14363 User Manual

Section 7

Program Setup

Output

AXIS AFP IOP User's Manual
The menupoints under menu [SETUP] relate mainly to the setup of the
program in combination with the PC. Only option under [SETUP]
affecting the AFP IOP interface is found under [Output].
Output.....................................................................................................
Download is only supported on a serial COM port. In the [Output]
selection in the [Setup] menu a COM port from 1-4 can be selected. If a
port is selected which is not available on the PC used, an error message
window will appear on the screen. Also the baud rate for communicating
with the AFP IOP is selected under [Output]. The AFP IOP
automatically detects the selected baud rate. The default baud rate is
19200 and the highest baud rate is 57600 which should work on most
modern PC's. If communications problems occur during download and
upload then check that the PC and the Printer uses a common ground
(not through the serial cable). If not, then connect the devices to a
common ground or select a baud rate of 19200 or lower. If baud rate is
changed after linking with the AFP IOP has been established, the printer
has to be restarted and the [Remote Setup] activated before a new
download/upload is performed.
Section 7: Program Setup
63