Opening Screen (Main Iop Menu) - Axis 14363 User Manual

Section 2: Front Panel Operation

Opening Screen (Main IOP Menu)

Note:
12
The first display under [Network Menu] is shown in figures 1 and 2.
Notice the following about the displays:
1. The detected cable type -Coax or Twinax is displayed in the upper left
corner. However if no cable is connected, the display will indicate
"Twinax".
2. Synchronization with the Coax or Twinax Control Unit is displayed as
"CU". However the display does not operate in real time mode, but is
only updated when entering [Network Menu]. This means unsteady
lines or later disconnection will not be indicated, and the CU indica-
tion is not a guarantee for a proper connection.
3. The emulation indication in the lower left corner shows the power on
emulation. If the emulation is changed in the [IPDS Options] menu
the display will show the previous emulation until next power on.
4. The "D" next to the emulation indicates if a duplex unit has been
detected or if duplex has been enabled in the [Duplex Support] menu.
This detection only works on Optra and 4039 Plus models.
The "D" indication will also be displayed in 4028 emulation, even though
an original IBM 4028 does not support duplex (The AFP IOP can print
IPDS duplex in all emulations).
Figure 1.
Coax Local Setup
CU Remote Setup
Test Options
3816D
Ready Return
AXIS AFP IOP User's Manual