C15; C16 - Axis 14363 User Manual

C15

Note:

C16

AXIS AFP IOP User's Manual
Early Print Complete Response Timing ......................[c15 Print Release]
This is used to control when the printer will acknowledge a Form Feed
(both an automatic FF and a valid FF control code). This option is only
valid for non-IPDS mode.
This option is inverted compared to the 3812/3816 printers. On the
3812/3816 C15 = 0 means that the FF will not acknowledge until
printing is physically completed.
• 0 [Processing] The FF will be acknowledged when the page has been transferred
to the page buffer in the printer. With this setting you can achieve
the maximum throughput, but you may lose data on an IR or if the
printer loses power.
1 [Printing] For DSC/DSE print the FF will not be acknowledged until the print
is physically completed. For LU-1 (SCS) print the printer will func-
tion as if this option was set to zero provided that the chaining
techniques are not used (Please refer to PCIA address X'0017' Bit
number 1 & 2). However, if the FF (automatic or as control code)
is found in a Last or Only segment, the FF will not be acknowledged
until the print is physically completed.
IPDS Parser syntax (with default setting):
COAX_C15 = 0;
Automatic Function at End of OILC Job............... [c16 At end of OILC]
Used in DSC/DSE modes only.
• 0 [No Auto Func.]
1 [Auto Function]
IPDS Parser syntax (with default setting):
COAX_C16 = 0;
Section 5: Configuration Parameters
The setting of C24 controls how the printer handles the end of
a print-order.
Form feed is executed after the print buffer has completed a
local copy job.
29