Transmission/O-Ring Seal Removal; Rear Strut Removal - Maytag Neptune TL FAV6800A Service

Disassembly Procedures
!
5. Lift out Tumbler Bearing.

Transmission/O-Ring Seal Removal

1. Disconnect power supply to unit.
2. Lift lid.
3. Remove left and right Tumbler.
4. Remove left and right Tumbler Bearing.
5. Remove 4 Transmission mounting bolts.
LEFT
6. Lift Transmission Assembly from washer.
CAUTION: When working around stamped metal,
edges may be sharp.
NOTE: Bolt pattern is designed to orient Transmission
one way.
NOTE: It is recommended the O-Ring Seal be replaced
if the Transmission is removed. When Replac
ing Transmission O-Ring Seal. Apply a small
amount of detergent for lubrication before install
ing new O-Ring Seal.
NOTE: A small amount of oil under the transmission is
normal.
Transmission O-Ring Seal
40
WARNING
BACK
RIGHT
16022808 Rev. 0
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
7. When installing Transmission align arrow on Spin
ner Support with arrow on Transmission Housing.
8. Tighten Transmission mounting bolts in a cross
pattern. Seat the bolt to the Transmission Housing
and then snug bolt down.

Rear Strut Removal

1. Disconnect power supply to unit.
2. Lift Top Cover.
3. Remove the Strut Assembly mounting screws.
Strut Assembly
Mounting Screws
©2003 Maytag Appliances Company