Drive Motor Removal - Maytag Neptune TL FAV6800A Service

Disassembly Procedures
!
7. Remove left and right Tumbler Bearings.
8. Remove 4 Transmission mounting bolts.
9. Lift Transmission Assembly from washer.
10.Lock Spinner position with Short extension.
11. Remove 6 Spinner mounting bolts.
12.Lift Spinner From Washer.
13.Remove Drain Pump Hose From Outer Tub.
14.Unplug Motor Harness from Motor.
15.Remove Motor Harness Strain Relief attached to
Outer Tub.
16.Unplug Heater Harness from Heater Assembly.
Remove Heater Harness Strain Relief from Outer
Tub (Heater Models Only).
17.Unhook Tub Displacement Sensor and tuck out of
way.
46
WARNING
Strain Relief And
Screw
16022808 Rev. 0
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
18.Unhook Rear Struts From Outer Tub. Press the Rear
Strut Rod near the connection point to the tub.
19.Roll Outer Tub over pivoting on the Front Struts for
support.
20.Lift Outer Tub from washer and set on side or top.

Drive Motor Removal

1. Disconnect power supply to unit.
2. Lift Top Cover.
3. Remove Front Panel.
4. Unplug Motor Harness from Motor.
5. Loosen Drive Motor tension bolt.
Loosen Bolt
©2003 Maytag Appliances Company