Removing The Tub Ring And Basket - Maytag Pet Pro Technical Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
Lifting the Top Panel
NOTE: There is a new hook at the front left and right of the top panel that needs
to be disengaged to remove top panel.
1. Unplug washer or disconnect power.
2. Turn off water supply to washer.
3. Disconnect hot and cold inlet water hoses.
4. Tape lid down.
5. Remove three (3) 1/4" (6 mm) hex-head mounting screws from the rear
of the console as indicated. Remove harness cover and set aside.
6. To remove the top panel, a tool such as a stiff putty knife must be used.
Slide the putty knife in between the cabinet and the top panel in the front
corner as shown in Figure 1. The putty knife will allow the top to be slid
forward slightly and removed. Repeat on other front corner. Carefully
use these tools to avoid damaging the finish on the consumers unit.
NOTE: Wrap a tape around a putty knife or add a tape to chassis to
avoid the damageto the unit.
A. Putty Knife
B. Slot
38
FOR SERVICE TECHNICIAN'S USE ONLY

Removing the Tub Ring and Basket

B B
A A
Figure 1
Figure 2
A. Tab on Underside of Top Panel
7. Slide the Top Panel forward about 1/2" (13 mm).
8. Raise the Top Panel about 1/4" (6 mm). While keeping it lifted, push the
Top Panel back about 1/4" (6 mm).
9. Tilt the Top Panel up and make sure that the rear tabs slide into the slots
as shown in below figure.
A A