Maytag Neptune TL FAV6800A Service page 38

Disassembly Procedures
!
6. Tip Tumbler Assembly forward and pull up to remove.
Tumbler Assembly may need to be rocked back and
forth to free it from bearing surface.
Pull
Tip
NOTE: When sliding Tumbler past Balance Ring on
spinner, orient the Tumbler upside down to reduce
the risk of marring the Balance Ring.
During reassembly orient the Tumbler facing up.
38
WARNING
Angle
16022808 Rev. 0
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.
IMPORTANT: Right and left Tumbler Assemblies are
not the same, and should not be reversed. Identify the
correct Tumbler by looking at the back for an "L" or "R"
molded into the plastic. The Tumbler Assemblies also
have timing marks that must be aligned for proper
operation. Rotate the Tumbler by hand to align the
timing marks at the bottom of the Tumbler revolution as
shown.
7. Reinstall Tumbler Assembly in reverse of
disassembly by setting bottom edge in place first, and
rotating back into position. The Tumbler, when
properly seated will "POP" into place.
Tumbler Side
Designation
IMPORTANT: The spinner also has "L" and "R" molded
into the plastic under the tumbler. Insure the correct
tumbler is used for the corresponding side of the spin-
ner.
Tumbler Side
Designation
©2003 Maytag Appliances Company