Connection Diagrams - Blaupunkt TRAVELPILOT FREESTYLER Operating And Installation Manual

Slide the device 1/3 of its length into
the installation compartment.
Undo the gyroscope screw.
Use the hexagonal wrench to adjust
the position of the gyroscope so that
the marker is in a vertical position and
forms a 90° angle with the horizontal.
Tighten the gyroscope screw again.
Now, by gently pressing on both ends
of the frame, push the TravelPilot in
until the side spring latches on the left
and right lock into place (you will hear
a clear clicking sound).
Caution! When pushing in the device,
do not press on the display or any of
the buttons or switches!
4.3 Removing the TravelPilot
Detach the control panel. You must
now insert the stirrups into the desig-
nated holes on the left and right of the
surround panel and push them in until
you hear a clear clicking sound (side
springs unlocked). Now carefully pull
on the two stirrups to extract the
TravelPilot. The connecting cables can
now be disconnected by pressing on
the sides of the clips on the respective
plug-and-socket connections
Fig. 5).
Note: The clipped in stirrups can only
be detached after the TravelPilot has
been pulled out.
4.4 Connecting the reversing light
signal (only TravelPilot E
with speed signal)
Lay a cable from the reversing light to
pin 3 of chamber A (see Fig. 8). You
must make sure that +12 V are present
at the connection when the vehicle re-
verses.
Note: If it is not possible to connect to
the reversing light, you must connect
pin 3 to earth. This might lead to navi-
gation inaccuracy since the Travel-
Pilot will not be able to detect whether
the vehicle is reversing.
Caution! We do not accept liability for
incorrect connections and their conse-
quences.
4.5 Connecting the speedometer
signal (only TravelPilot E
and
The connection is made using a cable
from the vehicle-specific speedometer
signal connection to pin 1 of chamber
A (see Fig. 8).
(see
5. Sensor test

6. Connection diagrams

Electrical connection to the
vehicle-specific plugs ................. Fig. 1
Loudspeaker connection
(4 x 4 Ω/35 W) ........................... Fig. 2
Antenna connection ................... Fig. 3
TravelPilot installation ............... Fig. 4/4a
Removing the TravelPilot .......... Fig. 5
Gyro adjustment ........................ Fig. 6
)
Connection configuration ........... Fig. 7
Assignment of connections,
chamber A. ................................ Fig. 8
Caution! This connection should be
carried out by one of the vehicle man-
ufacturer's authorized workshops.
Caution! We do not accept liability for
incorrect connections and their conse-
quences.
After carrying out the installation, you
should test the connected sensors us-
ing the sensor test (see operating in-
structions / Setup - Basic settings / In-
stallation).
98