Table of Contents
Advertisement
INTRODUCTION
NAVIGATION
Switching the device on/off
1 To switch on your TravelPilot E, press button 3.
The device plays the last active audio source at the volume level that was
set when the device was last switched off. You can limit the power-on vol-
ume to a maximum value.
Note: You can find out how to limit the power-on volume in the sec-
tion entitled "Configuring the power-on / navigation / traffic an-
nouncement / telephone volume and GALA settings" in the "Setup -
basic settings" chapter.
1 To switch off the device, press and hold down button 3 for longer than
2 seconds.
Switching on/off using the vehicle ignition
The TravelPilot E will switch on/off simultaneously with the vehicle ignition if it is
correctly connected to the vehicle ignition and if you did not switch off the
TravelPilot by pressing button 3.
You can also operate the TravelPilot E when the ignition is off.
1 To do so, press button 3.
The device switches off automatically after an hour so as to protect the vehicle
battery. You can repeat this procedure as often as you like. The imposed time
limit is cancelled as soon as the ignition is turned on.
Note: To ensure that the TravelPilot E functions properly, the device must
be connected to the permanent positive power source and to the positive
power source via the ignition as described in the installation instructions.
The standby time that elapses after the device is switched off has been
set to 30 minutes.
RADIO
CD / MP3
CD CHANGER
SETUP
3
APPENDIX
14
Hide quick links:
Advertisement
Table of Contents
