Table of Contents
Advertisement
Important notes
What you must know!
Before starting to use your new car radio, you
should carefully read through the following
information.
Traffic safety
As the driver of a motor vehicle, it is your
responsibility to pay attention to the traffic
situation at all times. Never use your car radio
in a way that could distract you.
Please keep in mind that you travel a di-
stance of 14 m per second at a speed of only
50 km/h.
Should the traffic situation become particu-
larly demanding, we would advise you not to
use the radio.
When adjusting the volume, make sure that
you are still able to hear all sounds coming
from outside of the vehicle, so that you are
always able to react to warning signals, for
example from the police or the fire brigade.
Installation/connection
If you like to install your new car radio by
yourself or add other audio components to
the existing ones, then please read carefully
the enclosed instructions on installation and
connection.
Optical indication of theft protection
When the car is stationary, you can let the
KeyCard tongue flash in order to show that
the set is theft-protected. DSC allows you to
adjust two different settings: LED ON or LED
OFF.
For more information, please read through
chapter "DSC programming - LED ON/OFF".
KeyCard
This car radio cannot be operated unless the
corresponding KeyCard is inserted. The
KeyCard code is stored in the set.
Turn on the set and introduce the KeyCard
completely. The car radio is now ready for
operation. When inserting a wrong KeyCard,
the display will show "----".
After approximately 10 seconds the display
shows CARD ERR.
In this case do not go on operating the set
until you have the corresponding KeyCard
available.
Never try to pull out the KeyCard by force.
First, slightly push in the card, which will then
be released (the display shows LEARNING),
and then remove it.
Should you have lost your KeyCard, or if it
has become damaged, please contact one of
our authorised service partners to get a new
card.
Blaupunkt also offers designer KeyCards for
an additional fee.
You can find the service providers listed in
the car radio service register ( ). In case of
doubt, please contact the central service
centre in your country for more information
on the next KeyCard service facility in your
vicinity.
The following functions can be individually
stored with the KeyCard (1 and 2): bass,
treble, balance and fader settings, preset
stations, loudness, TA (volume of traffic an-
nouncements), SPEECH (tone control for
speech programs), BEEP volume, SCANTI-
ME, VOLFIX.
Moreover, the parameters adjusted last such
as the waveband, station, TA priority, loud-
ness, AF, CPS, Dolby B, RM, REG ON/OFF
or seek tuning sensitivity remain stored.
With this, you will always find your basic
settings adjusted again after you have inser-
ted your KeyCard.
25
Advertisement
Table of Contents
