Table of Contents
Advertisement
Note: Any memory available after the corridor has been loaded will
be used to store the data for the surrounding area function. The CD
symbol at the bottom right of the display indicates when data are
being loaded. Data are loaded even if there is no navigation session
currently active.
You will be asked to insert the navigation CD in certain situations when the
device needs to load new data from the CD. If you do not insert the navigation
CD after being asked to do so during the active navigation session, a compass-
card symbol will appear in the display.
Notes: If a navigation session is active within the stored corridor
and you insert a CD-ROM containing navigation software that is dif-
ferent to the software already installed on the device, the system
will ask you whether you want to load this new software into the
device. If you decide to go ahead with this download, the system
will cancel the currently active navigation session. If you do not go
ahead with the download, a compass-card symbol will appear in the
display after your vehicle leaves the corridor.
Starting navigation
1 Whilst the device is switched on, press the NAV button 1.
The main navigation menu appears.
The following destination selection options are available in the main navigation
menu:
LAST 10: Access the last 10 destinations
DESTination INPut: Enter a destination by specifying an address
Similar to the memory banks in radio mode, the navigation system also has
several memory banks at its disposal (N1, N2, N3 and N4). You can store six
destinations in each of these memory banks using buttons 1 - 6 >.
INTRODUCTION
NAVIGATION
RADIO
CD / MP3
N1 NAVi
LAST 1O
DEST INP.
TMC
CD CHANGER
SETUP
NAV
23
APPENDIX
Hide quick links:
Advertisement
Table of Contents
