Table of Contents
Advertisement
Default
Description
Example
6.3
dot1x port-control (auto|force-authorized|
force-unauthorized)
Syntax
Parameters
Command Mode Interface mode
No/clear
Show
Default
Description
Example
GigaX2024B/M L2 Managed Switch CLI Manual
The default is 2
Use the dot1x max-req interface configuration command
on the switch stack or on a standalone switch to set the
maximum number of times that the switch sends an Extensible
Authentication Protocol (EAP)-request/identity frame (assuming
that no response is received) to the client before restarting the
authentication process. Use the no form of this command to
return to the default setting.
ASUS(config-if)#dot1x max-req 2
dot1x port-control (auto|force-authorized| force-unauthorized)
auto ->
and causes the port to begin in the unauthorized state, allowing
only EAPOL frames to be sent and received through the port
force-authorized -> Disables 802.1x port-based authentication
and causes the port to transition to the authorized state
without any authentication exchange required
force-unauthorized -> Causes the port to remain in the
unauthorized state, ignoring all attempts by the client to
authenticate
no dot1x port-control
show dot1x all / show dot1x interface IFNAME
The default is ForceAuthorized
Use the dot1x port-control interface configuration command on
the switch stack or on a standalone switch to enable manual
control of the authorization state of the port. Use the no form of
this command to return to the default setting.
ASUS(config-if)# dot1x port-control auto
Enables 802.1x port-based authentication
17
Advertisement
Table of Contents
