Command Mode Interface mode
No/clear
Show
Default
Description
Examples
15.13 auto-negotiation
Syntax
Parameters
Command Mode Interface mode
No/clear
Show
Default
Description
Examples
15.14 speed (10|100|1000)
Syntax
Parameters
GigaX2024B/M L2 Managed Switch CLI Manual
tx ->
control packets to a remote device
both ->
send flow-control packets from a remote device
off ->
attached device that is required to send or receive flow-control
packets
on ->
attached device that is required to send or receive flow-control
packets
No flowcontrol
show interface IFNAME
receive on, send on
This command sets the interface flowcontrol method.
ASUS(config-if)# flowcontrol both on
auto-negotiation
no auto-negotiation
show l2_interface IFNAME
None or depends on ODM customer
Use the auto-negotiation configuration command on the switch
stack or standalone switch to set auto-negotiation status of the
port.
ASUS(config-if)# auto-negotiation
speed (10|100|1000)
sets whether the interface can send flow-
sets whether the interface can receive and
disable an interface to operate with an
allows an interface to operate with an
199