GigaX2024B/M L2 Managed Switch CLI Manual
Command Mode Interface mode
No/clear
show
Default
Description
Examples
15.11 duplex (full|half)
Syntax
Parameters
Command Mode Interface mode
No/clear
Show
Default
Description
Examples
15.12 flowcontrol (rx|tx|both) (on|off)
Syntax
Parameters
198
discardall ->
vlan-tagged-only -> only vlan-tag frame is accepted
show interface IFNAME
None or depends on ODM customer
Use the acceptable frame type configuration command on
the switch stack or standalone switch to set the type of the
acceptable
frame, for any kind of frame type is accepted or only vlan-tag
frame is accepted.
ASUS(config-if)#acceptable frame-type all
duplex (full|half)
full ->
half ->
no duplex
show interface IFNAME
The default is Full
Use the duplex interface configuration command on the switch
stack or on a standalone switch to specify the duplex mode of
operation for Fast Ethernet and Gigabit Ethernet ports. Use the
no form of this command to return the port to its default value.
ASUS(config-if)# duplex full
flowcontrol (receive|send|both) (on|off)
rx ->
control packets from a remote device
discard all frame is accepted
Port is in half-duplex mode
Port is in full-duplex mode
sets whether the interface can receive flow-