Wireless Lan Function Settings - Roland M-300 Owner's Manual Addendum

About the Wireless LAN Function

Wireless LAN Function Settings

You can check or alter the wireless settings using the steps below.
1.
Call up the REMOTE popup (WIRELESS LAN tab)
Press [SYSTEM] > [F4 (REMOTE)] > [F6 (WIRELESS LAN)]. You can call up the REMOTE popup (WIRELESS LAN tab).
* You can only use the wireless LAN function when the "Enable Wireless LAN" is checked.
fig.call-wireless-LAN-tab.eps
2.
Call up the WIRELESS LAN SETUP popup
Move the cursor to the SETUP button and press [ENTER] to call up the WIRELESS LAN SETUP popup.
fig.wireles-LAN-setup.eps
About the Status Display
• CONNECTED
The M-300 is connected to the wireless LAN access point. This part also shows the ID (name) of the access point.
• NOT CONNECTED
Although the wireless USB adaptor is connected, the M-300 is not connected to the wireless LAN access point.
• NOT AVAILABLE
The wireless USB adaptor is not connected.
• AD-HOC MODE
The unit is in Ad-Hoc mode. Refer to "Connecting in Ad-Hoc Mode" (p. 9).
• DISABLE
The wireless LAN function is disabled. The "Enable Wireless LAN" is not checked.
6