Roland M-300 Owner's Manual Addendum page 14

About the 31-band GEQ
About the Function Buttons
In the GEQ INSERT SELECT popup, the function buttons perform the following operations.
• [F6 (SELECT NONE) ]
• [F8 (CLOSE)]
Inserting the 31-band GEQ to MAIN L/R
This section describes the procedure for inserting linked GEQ1 and GEQ2 into the MAIN L/R channels.
1.
Access the EFFECTS screen, and press [F2 (GEQ 1-4)] to display the GEQ 1-4 tab.
fig.GEQ-Rack.eps
2.
Move the cursor to the LINK button located at the right of GEQ1 and GEQ2, and press [ENTER] to turn the button on.
3.
Move the cursor to the GEQ INSERT SELECT popup button for GEQ1, and press [ENTER].
The GEQ INSERT SELECT popup will appear.
fig.GEQ-InsSel.eps
4.
Move the cursor to the MAIN L insert-destination channel select button, and press [ENTER] to select it.
5.
Press [F8 (CLOSE)] to close the popup.
6.
In the same way as you did in steps 1 through 5, select MAIN R as the insert destination for GEQ2.
14
This clears the insert-destination selection.
This closes the popup.