Roland M-300 Owner's Manual Addendum page 8

About the Wireless LAN Function
Connecting to a Wireless LAN Access Point That You Select (Access Point Select)
This method lets you connect by choosing a wireless LAN access point from the list that is displayed.
* Wireless standards 802.11g/n (2.4 GHz) and authentication methods WPA/WPA2 are supported.
1.
Call up the REMOTE popup (WIRELESS LAN tab)
Press [SYSTEM] > [F4 (REMOTE)] > [F6 (WIRELESS LAN)] to call up the REMOTE popup (WIRELESS LAN tab).
2.
Call up the WIRELESS LAN SETUP popup.
Move cursor to the SETUP button and [ENTER] to call up the WIRELESS LAN SETUP popup.
fig.call-setup-popup.eps
3.
Call up the ACCESS POINT SELECT popup
Press [F1 (AP SELECT)] to call up the ACCESS POINT SELECT.
* The currently selected access point is shown in green.
* Press [F4 (REFRESH)] to update the list.
fig.access-point-select.eps
Characters other than single-byte alphanumerics cannot be displayed correctly in the list of access point names.
4.
Select the access point
Select the wireless LAN access point that you want to connect to and press [F8 (SELECT)].The unit will start to connect with the
selected access point.
* If you are using this wireless LAN access point for the first time, you will proceed to the authorization (PASS) screen.
* If this is a wireless LAN access point that you have connected to in the past, just press the [F8 (SELECT)] button.
5.
Input the security information
Input the security information of the wireless LAN access point (Passphrase) and press [F8 (CONNECT)].
* For details of character input, refer to the owner's manual of the M-300.
* You cannot input any blank space after the Passphrase.
fig.passphrase-input.eps
8