New functionality for scene memory
• A fade function has been added.
• Detailed settings have been added for the Recall Filter function, enabling the individual range to be set independently for channels, DCA/MUTE
groups, and effects.
Fade function
The fade function makes parameters change gradually over a specific interval when a scene memory is recalled.
The fade function can be set individually for each scene.
The parameters for which the fade function is enabled are shown below.
• Faders for the respective channels
• Pan (or balance) for the respective channels
Using the fade function
1.
At the SCENE MEMORY section, press [DISP].
The SCENE screen is displayed.
fig.scene-screen.eps
When the fade function is enabled for a scene memory, FADE is displayed in the STATUS field for the scene memory on the scene list at the SCENE screen.
2.
From the scene list, select the target scene, then press [F4 (PARAM EDIT)].
This accesses the RECALL PARAMETER EDIT popup.
fig.recall-param-edit.eps
3.
Check the [USE FADE] box.
fig.use-fade-box.eps
4.
Set the fade time.
5.
Press [F8 (OK)] to apply the changes and close the popup.
Recalling a scene memory for which the fade function is enabled and then again recalling the same scene memory causes the values registered to
the scene memory to be updated instantly.
18