Paper Misfeed In The Bridge Kit; Paper Misfeed In The Inner Finisher And The Hole Punch Unit - Toshiba E-studio 2051c Troubleshooting Manual

1 TROUBLESHOOTING FOR THE HARDWARE
 Paper misfeed in the Bridge Kit
1 Open the cover holding the handle of the Bridge Kit.
2 Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right side is
caught by the fuser unit, follow the steps on  P.23 "Paper misfeed
in the fuser unit".
Close the Bridge Kit cover.
3
 Paper misfeed in the Inner Finisher and the Hole Punch Unit
Lift up the control panel and then open the front cover
1
of the finisher.
While holding the green lever, move the finisher to the
2
left until it stops.
26 Clearing a Paper Misfeed
1
2
2
1