Hardware Problems; Print Jobs Not Output - Toshiba E-studio 2051c Troubleshooting Manual

Hardware Problems

This section describes troubles caused by the hardware device (the equipment).
If an icon or a message indicating an error is not displayed, or the problems in the printer drivers or the network connection
cannot be specified, a hardware problem is a possible cause of the trouble.
The following are common factors involved in the hardware problems:
 System board, cables, and connectors
 The equipment, and its components such as the duplexing unit or the Finisher
 System software or firmware of the equipment
 Print jobs not output
Problem Description
All the clients within a network fail to make the equipment output the print jobs.
Corrective Action
There remains a possibility that improper settings of the software such as printer drivers caused the problem. However, a
hardware error is possible, if none of the clients can print the jobs. Try the steps on the checklist below. If the problem
persists after you have followed all of the steps, contact your service representative.
No Check...
1 Is printing prohibited from all connected client
computers?
2 Can you see the job from TopAccess or another
print monitoring utility, such as PCONSOLE or
Print Manager?
3 Can you identify the problem with the error
message or the error code and resolve it?
Also refer to the Printing Guide for more information on resolving output errors caused by software settings.
Yes No Corrective Action
See the following section to fix the problem:
Next Step


 P.72 "Network Connection Problems"
See the following section to fix the problem:
Next Step
  P.84 "Locating the Equipment in the Network"

See the following sections to fix the problem:
  P.98 "Error Messages"
End
 P.100 "Error Codes"
3 TROUBLESHOOTING FOR PRINTING

Hardware Problems

75