Table of Contents
Advertisement
Chapter 5 WAN Setup
5.2 Internet Connection Screen
Use this screen to change your ZyXEL Device's WAN settings and assign an egress
queue to an interface. Click Network > WAN > Internet Connection. The
summary table shows you the configured WAN services (connections) on the
ZyXEL Device as well as the egress queue information.
Note: You can configure up to eight (8) WAN interfaces for your ZyXEL Device.
Note: To use NAT or ICMP Response in the ZyXEL Device, you need to configure a
WAN connection with PPPoE or IPoE.
Figure 17 Network > WAN > Internet Connection
The following table describes the labels in this screen.
Table 10 Network > WAN > Internet Connection
LABEL
Wide Area Network (WAN) Service Setup
Interface
Description
Type
Service Type
VlanId
Vlan802.1p
Egress Queue
76
DESCRIPTION
This shows the name of the interface used by this connection.
This is a brief description of this connection.
This shows the method of encapsulation used by this connection.
This shows the service that passes through the interface.
This indicates the VLAN ID number assigned to traffic sent through
this connection. This displays N/A when there is no VLAN ID number
assigned.
This indicates the 802.1P priority level assigned to traffic sent through
this connection. This displays N/A when there is no priority level
assigned.
This identifies the egress queue of the outgoing traffic flow for this
interface.
FSG2200HNU User's Guide
Advertisement
Table of Contents
