ZyXEL Communications FSG2200HNU User Manual page 195

Table 61 Advanced > QoS > Class Setup: Add/Edit
LABEL
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
Source
MAC Address
MAC Mask
IP Address
IP Subnet
Mask
TCP/UDP Port
Range
Exclude
Destination
IP Address
IP Subnet
Mask
TCP/UDP Port
Range
Exclude
Others
IP Protocol
DSCP
FSG2200HNU User's Guide
DESCRIPTION
Select from which Ethernet port or wireless interface traffic of this
policy route should come.
Select the check box and enter the source MAC address of the packet.
Type the mask for the specified MAC address to determine which bits
a packet's MAC address should match.
Enter "f" for each bit of the specified source MAC address that the
traffic's MAC address should match. Enter "0" for the bit(s) of the
matched traffic's MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
Select the check box and enter the source IP address in dotted
decimal notation.
Enter the source subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
Select this option to exclude the packets that match the specified
criteria from this classifier.
Select the check box and enter the destination IP address in dotted
decimal notation.
Enter the destination subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
Select this option to exclude the packets that match the specified
criteria from this classifier.
Select this option and choose either TCP or UDP protocol (service
type).
Select this option and specify a DSCP (DiffServ Code Point) number
between 0 and 63 in the field provided.
Chapter 15 Policy Route
195