Table of Contents
Advertisement
Chapter 5 WAN Setup
IPoE
This screen displays when you select IP over Ethernet.
Figure 20 Network > WAN > Internet Connection > Add/Edit: WAN IP Settings
(IPoE)
The following table describes the labels in this screen.
Table 13 Network > WAN > Internet Connection > Add/Edit: WAN IP Settings (IPoE)
LABEL
Obtain an IP
address
automatically
Enable DHCP
Option 60
Vendor Class
Identifier
Use the following
Static IP address
WAN IP
Address
WAN Subnet
Mask
WAN gateway
IP Address
Enable NAT
Enable ICMP
Response
82
DESCRIPTION
A static IP address is a fixed IP that your ISP gives you. A dynamic IP
address is not fixed; the ISP assigns you a different one each time you
connect to the Internet. Select this if you do not have a static IP
address.
Select this to identify the vendor and functionality of the ZyXEL Device
in DHCP requests that the ZyXEL Device sends to a DHCP server when
getting a WAN IP address.
Enter the Vendor Class Identifier (Option 60), such as the type of the
hardware or firmware.
Select this if you have a static IP address.
Enter the static IP address provided by your ISP.
Enter the subnet mask provided by your ISP.
Enter the gateway IP address provided by your ISP.
Select this option to enable full cone NAT on the ZyXEL Device.
Internet Control Message Protocol (ICMP) is a message control and
error-reporting protocol between a host server and a gateway to the
Internet. Select this check box to have the ZyXEL Device enable this
feature.
FSG2200HNU User's Guide
Advertisement
Table of Contents
