Foxconn Bloodrage User Manual page 29

System mounts. If your mainboard is mounted vertically inside a standard case and you still wish
to use the Heatsinks we recommend securing them with a drop of superglue in each corner of the
Heatsink.
Note: FOXCONN do not guarantee the reliability of accessaries.
2. Install the Quantum Stream Water Block
We recommend assebling the watercooling loop outside the system and not mounted on the ac-
tual hardware to perform some leak-testing before installing the waterblocks on the CPU, chipset,
VGA etc.
Pull both ends of the tubing through the secure-rings (bundled) and then push the tubing over
the waterblock fittings. Make sure the fittings are completely inside the tubing, then pull down the
rings onto the ends of the tubing and fasten them with a screwdriver. If your watercooling loop
proves to be watertight and there are no drops of water forming anywhere, then proceed and
install the waterblocks one by one.
Remove the 4 screws holding the Northbridge Heatsink in place, remove the Heatsink and clean
the remaining thermal grease. Then apply some fresh thermal grease (bundled) and fasten the
waterblock on the copper base using the original 4 screws.
3. Install the Extreme Cooling Tube
Place the Extreme Cooling Tube above the heatsink and fix it by four screws. Cooling Tube allows
extreme overclockers to use Dry Ice or Liquid Nitrogen as a cooling media. But it is at your own
risk!!
22