Install The Cpu Cooler - Foxconn Bloodrage User Manual

Install the CPU Cooler

Follow the steps below to correctly install the CPU cooler on the motherboard. The Foxconn
QuantumForce BloodRage comes equipped with socket 1366 and socket 775 mounting holes to
support current Heatsinks, waterblocks, phase change coolers and DI/LN2 pots without the need
for modifications or upgrade kits.
Socket 775 Push-Pin Heatsinks like the Intel 775 stock Heatsinks will NOT fit properly
since the 1366 CPU socket is slightly higher than the 775 CPU socket!
1. Apply and spread an even thermal
grease on the surface of CPU.
3. Check the solder side of the
motherboard, the push pin should be
fixed as depicted in the picture.
3
2
1
2. Place the four bolts of the CPU
cooler to the holes of the motherboard,
push them straight down from the top,
and the bolts will be fastened on the
motherboard. That's it.
4. Attach the 4-wire CPU cooler
connector to the CPU fan socket on
the motherboard .
Release bolts of CPU cooler from
motherboard :
1. Turning the push pin (bolt)
along with the direction of arrow
(counterclockwise).
2. Pull the push pin straight up.
3. Turning push pin clockwise to its
default position.
11