Table of Contents
Advertisement
When the output sequence is Off , the bar code data is output to the host as the
imager decodes it.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Required
On/Not Required
*Off
Multiple Symbols
When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the imager's trigger. If you press and hold the
trigger, aiming the imager at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The imager attempts to find and decode
new symbols as long as the trigger is pulled. When this programming selection
is turned Off , the imager will only read the symbol closest to the aiming beam.
On
* Off
No Read
With No Read turned On , the imager notifies you if a code cannot be read. If
using a Quick*View Scan Data Window, an "NR" appears when a code cannot
be read. If No Read is turned Off , the "NR" will not appear.
On
* Off
2020/4820/4820i User's Guide
4 - 17
Advertisement
Table of Contents
