Multiple Imager Operation - Hand Held Products 4820 User Manual

Multiple Imager Operation

Note: Multiple Imager Operation Mode allows you to link up to 7 imagers to one
base. You cannot join an eighth imager until you unlink one of the 7
imagers or take an imager out of range.
To put the imager in multiple imager mode, scan the bar code below. Once you
scan this bar code, the imager is unlinked from the base and must be placed into
the base to re-link.
2020/4820/4820i User's Guide
Multiple Imager Operation
3 - 7