Table of Contents
Advertisement
Alternatively, you may change the name with a bar code command if you cannot
send serial commands to the base. One way to do this is to scan the bar code
below and scan a number for the imager name. For example, if you had 7
imagers to one base, scan the bar code below with the first imager, scan the 1
bar code on the
Programming Chart
inside the back cover of this manual and
scan Save. Then scan the Reset bar code and wait for the scanner to re-link to
the base before scanning the next bar code. Repeat that process for imager
number 2, 3, 4 etc.
Imager Name
If you want to assign an alphabetic name to the imager, create a Code 128 bar
code containing "~BT_NAM name ." followed by a FNC3 character (hexidecimal
83), where name is the new imager name. Scan the Reset bar code
(page 3-8
or on the
Programming Chart
inside the back cover of this manual). You may
use Barcode Builder, which is included with Quick*View. Refer to
Quick*View
on
page 11-5 for instructions about downloading Quick*View from the Hand Held
Products website:
www.handheld.com
.
Imager Report
Scan the bar code below to generate a report for the connected imagers. The
report indicates the port, work group, imager name, and address.
Imager Report
Application Work Groups
Your cordless system can have up to seven imagers linked to one base. You can
also have up to seven work groups. If you want to have all of the imagers'
settings programmed alike, you don't need to use more than one work group. If
you want each imager to have unique settings (e.g., beeper volume, prefix/suffix,
data formatter), then you may program each imager to its own unique work group
and may program each imager independently. For example, you might want to
have multiple work groups in a retail/warehouse application where you need to
have different data appended to bar codes used in the warehouse area versus
the retail area. You could assign all of the imagers in the retail area to one work
group and those in the warehouse to another. Consequently, any desired
changes to either the retail or warehouse area would apply to all imagers in that
particular work group. Visual Xpress
(page
11-4) makes it easy for you to
program your system for use with multiple imagers and multiple work groups.
2020/4820/4820i User's Guide
3 - 9
Advertisement
Table of Contents
