Table of Contents
Advertisement
Multiple Symbols
When this programming selection is turned On , it allows you to read multiple
symbols with a single pull of the scanner's trigger. If you press and hold the
trigger, aiming the scanner at a series of symbols, it reads unique symbols once,
beeping (if turned on) for each read. The scanner attempts to find and decode
new symbols as long as the trigger is pulled. When this programming selection
is turned Off , the scanner will only read the symbol closest to the aiming beam.
Multiple Symbols On
* Multiple Symbols Off
No Read
With No Read turned On , the scanner sends an "NR" to the host if you pull and
release the trigger without reading a code (e.g., bad bar code). If No Read is
turned Off , the "NR" will not be sent to the host.
No Read On
* No Read Off
If you want a different notation than "NR," for example, "Error," or "Bad Code,"
you can edit the output message using the
Data Formatter
(page 5-5). The hex
code for the No Read symbol is 9C.
Video Reverse
Video Reverse is used to allow the scanner to read bar codes that are inverted.
The "Off" bar code below is an example of this type of bar code.
Note: If additional menuing is required, Video Reverse must be disabled to read
the menu bar codes and then re-enabled after menuing is completed.
Video Reverse On
* Video Reverse Off
3 - 12
IMAGETEAM™ 2020/5620 System Manual
Advertisement
Table of Contents
