Table of Contents
Advertisement
Imager Name
You may assign a name to each imager you are using. When you have multiple
imagers linked to one base, you may want to name each imager so you will be
able to control the imager receiving imaging commands sent from the base.
The default name for a 4820 is "4820," and "4820i" for a 4820i. If you have more
than one imager linked to a base, and they all have the default names, the first
imager linked to the base receives commands. You can change the name of an
imager using a serial command (refer to
a bar code command. To change the name serially, unlink all except one of the
imagers from the base. Send ":4820:BT_NAM name ." or
":4820i:BT_NAM name .", where name is the new imager name. If you wish to
change the names of additional imagers, re-link them one at a time and repeat
the ":4820:BT_NAM name ." or ":4820i:BT_NAM name ." command for each
imager.
To rename imagers with sequential, numeric names, scan the bar codes below.
Scan the Reset code after each name change and wait for the scanner to re-link
to the base before scanning another bar code to rename the next imager.
3 - 8
0001
0003
0005
0007
"Imager Name"
2020/4820/4820i User's Guide
on page 12-8) or using
0002
0004
0006
Reset
Advertisement
Table of Contents
