Assembling The Battery Charge Sleeve Kit - Hand Held Products 4820 User Manual

Assembling the Battery Charge Sleeve Kit

Attach Tether
1. Use the phillips screw to connect the metal
ring of the coiled tether to the battery charge
sleeve.
2. Peel the backing from the
metal plate on the coiled
tether and affix the metal
plate to the back of the 2020
base.
Note: For best adhesion, allow
a 24 hour cure time
before placing stress on
the metal plate.
Remove Battery
Remove the end cap of the imager (turn the
thumbwheel or use a hex wrench).
2020/4820/4820i User's Guide 14 - 3