Table of Contents
Advertisement
Using the Imager with Bluetooth Devices
The imager can be used either with the 2020 base or with other Bluetooth
devices. Scanning the Non-Base Bluetooth Connection bar code below allows
the imager to be used with other Bluetooth devices (e.g., PDA, PC - Bluetooth
USB Adapter). After you scan the bar code below, follow the instructions
supplied with your Bluetooth device to locate the imager and connect to it. If you
go out of range with your imager, the imager automatically reconnects to the
Bluetooth device when it is back in range. If you want to re-link to the 2020 base,
"Single Imager Operation"
"Multiple Imager Operation"
refer to
on page 3-5 or
on
page 3-7 .
Note: The multiple work groups option is not available when you are using the
imager with Bluetooth devices other than the 2020 base.
Non-Base BT Connection
Changing Bluetooth PIN Code
Some devices require a PIN code as part of the Bluetooth security features. Your
imager's default PIN is 1234, which you may need to enter the first time you
connect to your PDA or PC. The PIN code must be between 1 and 16 characters.
To change the PIN, scan the bar code below and then scan the appropriate
numeric bar codes from the
Programming Chart
inside the back cover of this
manual. Scan Save to save your selection.
Bluetooth PIN
3 - 12
2020/4820/4820i User's Guide
Advertisement
Table of Contents
