Table of Contents
Advertisement
Insert Battery into Charge Sleeve
1. Place the squared-off end of the battery
into the sleeve and slide it until it stops.
The battery contacts should be show-
ing through the small rectangular open-
ing in the battery sleeve.
2. Press other end of the battery until you
feel a click.
Charge Battery
With the battery inside the battery charge
sleeve, place the battery charge sleeve into
the base with the battery contacts going in first
and facing up.
Troubleshooting Base
Note: Please visit the Services and Support section of our website
(www.handheld.com) to check for the latest software for both the imager
and the base.
If your base is not functioning properly, review the following troubleshooting
guidelines to try to isolate the problem.
Is the red LED on?
If the red LED isn't illuminated, check that:
• The power cable is connected properly and there is power at the power
source.
• The host system power is on (if external power isn't used).
Is the green LED on?
If the green LED isn't illuminated, check that:
• The imager is correctly placed in the base.
• There is external power or 12 volt host power.
• Charge mode is turned on.
14 - 4
(See "Base Charge Mode" on page
2020/4820/4820i User's Guide
3-3)
Advertisement
Table of Contents
