Table of Contents
Advertisement
Note: Scanning zero (0) is the equivalent of setting no time-out.
If there are no trigger pulls during the "imager power time-out timer" interval, the
imager goes into power down mode. Whenever the trigger is enabled, the
"imager power time-out timer" is reset. If the imager is placed in the 2020 cradle
and the battery is in the process of being charged, the imager will not go into
power down mode.
0 seconds
400 seconds
* 3600 seconds
Note: When the imager is in power down mode, pull the trigger to power the unit
back up. There will be a set of power up beeps and a delay of up to a few
seconds for the radio to join. The imager will then be ready to use.
2020/4820/4820i User's Guide
200 seconds
900 seconds
7200 seconds
4 - 5
Advertisement
Table of Contents
